Thursday, February 24, 2011

Set-up blunt nose

I set the spar, then milled and installed the support blocking. The blocking goes under each rib and between the ribs unless it's on the flats. The nose and tail get support blocking also. I haven't installed the shims yet but, I put a few out so you could see where they'd go. The spar is held in place by finger blocking on the support blocking and stop blocks in the flats. That'll get removed after the ribs and stringers are glued to the spar. I'll update the final set-up tomorrow after the shims are in place.


No comments:

Post a Comment